This bowl is pressed out of one piece of stainless steel plate, then the stainless drop-pipe is welded in and the stainless nipple attached. Very simple and reliable, and a very good price. Nipple incorporates flow adjustment and filter. 15mm (½”) fitting. Bowl size is 9cm x 7cm.
Big enough for sows. Small enough for weaners. Easy to clean. Simple to operate. Cheap as can be. Simple push-button operation is trouble free, and leaves the bowl clear for easy removal of straw or dirt. Cast iron bowl with brass valve. Bowl opening 12cm x 15cm. Suitable 5 to 65 psi by adjustment of flow-control device in valve. (Use large orifice for low water pressure.)
Heavy duty galvanised cast iron angle brackets with strong mounting plate. Securing holes of 8mm diameter at 55mm (15mm) and 60mm (20mm) spacing. Angled as listed above (as degrees below horizontal if mounted vertically).
Good quality stainless steel 45 brackets to suit 15mm and 20mm water nipples. Mounting dimensions: 15mm bracket holes 55mm centres, 20mm bracket holes 60mm centres. Holes 8mm diameter.
Machined in one piece with hexagon nut for easy servicing. Ideal for fatteners or sows. Suit pressures from 15 to 50 psi. Fine mesh domed filter for best service. Adjustable flow rate. (O-ring 207 157 suits 15 and 20mm nipples.)
This nipple is made for slop, or wet/dry feeders, where the pig can operate to wet feed as required. It is not suitable for pigs to drink directly from. Use to upgrade your existing feeders. 15mm (½” BSP) fitting. Replacement parts as for Fattener nipple.
PVC pipe-compatible saddles for attachment of 1/8” NPT fittings, such as our Water Nipple Rabbit or Poultry. Drill a 12mm hole in PVC pipe as required. Boss on back of saddle will locate in hole. Glue and press fit. Saddle length 40mm. Dimension is normal pipe size. Pipe outside diameters to suit saddles are 21.5mm for 15mm saddle, and 27mm for 20mm saddle. Available in packs of 10 only.